Filter
Top Products
6/16 XT1
Tuner Operation
MAKE AM/FM BAND SELECTION
1. Press and release the MENU button until either the ENTER and MHz characters flash, or the ENTER
and kHz characters flash.
2. Press the ENTER button until either MHz or kHz stops flashing.
3. Press either UP or DOWN button to obtain MHz or kHz. (note – MHz is the FM band and kHz is the
AM band)
4. Either wait until the ENTER stops flashing or depress the ENTER button.
EZ Steps:
1. Press MENU once
2. Press ENTER
3. Press UP
4. Press ENTER (or wait 3 seconds)
SELECT AUTO OR MANUAL TUNING
1. Press and release MENU button until AUTO and ENTER flash.
2. Press ENTER button to stop flashing.
3. Press UP or DOWN button to change to a new tuning mode.
4. Press ENTER to switch to the new mode.
EZ Steps:
1. Press MENU twice
2. Press ENTER
3. Press UP
4. Press ENTER (or wait 3 seconds)
LISTEN TO PRESET STATIONS OR SCANS
1. Press and release MENU until P-SCAN and ENTER characters flash.
2. Press ENTER.
3. Preset stations or scans will continue to advance until the ENTER button is pressed.
EZ Steps:
1. Press MENU three times
2. Press ENTER
3. When desired station is playing, press ENTER
NOTE. Although the display only shows frequency steps of 0.1MHz, the actual tuning is done with
steps of 0.05Mhz. (in EU mode only)