Filter
Top Products
- 2 -
QUICK START
Installing Batteries
Using the MRC Remote – MRC88CTL, MRAUDIO8X8CTL
The MRC Remote is ready to be used with the MRC88CTL and MRAUDIO8X8CTL, group code “A8”.
Using the MRC Remote - BXAUDIO4X4CTL
The MRC Remote is ready to be used with the BXAUDIO4X4CTL. Similar to the MRC44 and
MRAUDIO4X4CTL, the MRC Remote cannot use the source select buttons 5 thru 8. The
BXAUDIO4X4CTL cannot be programmed to respond to buttons M1, M2, M3, M4, and ENTER
(Play/Select Tier 2).
Using the MRC Remote – MRC44CTL, MRAUDIO4X4CTL
Before using the MRC Remote, the group code in the MRC44CTL and MRAUDIO4X4CTL must be
changed. Open the Dragon-Drop IR software that is included with the MRC44CTL and
MRAUDIO4X4CTL. Select each keypad’s Base Options and change the group code.
The MRC Remote can only use the first four source select buttons (1 thru 4).
Changing the MRC Remote Group Code
The MRC Remote has the ability to change group codes. This feature allows the capability to make
the MRC Remote respond to specific zones only. To do this, remove the battery cover and the
batteries. Using the chart below (Figure A), determine which group code you would like to use and cut
the respective jumpers. Then, be sure to use the Dragon-Drop IR software to program the zones
unique group code.
1. Turn the unit over and remove the battery cover.
Press the battery cover Tab in towards the battery
cover and lift up.
2. Install 2 “AAA” batteries (Alkaline recommended).
Be careful to observe correct polarity for each
battery as shown and as marked on the inside of
the battery compartment.
3. Reinstall battery cover.