Filter
Top Products
-3-
PANEL LAYOUT AND DESCRIPTIONS
Front Panel
Back Panel
1
5
2
6
3
7
4
8910
Power LED1
This LED will activate once a valid power source is applied.
Internal EDID LED2
This LED will activate only when the pre-programmed internal EDID is being
used. Please see page 5 for more details on the internal EDID.
External EDID LED (default EDID routing)3
This LED will activate only when the external EDID is being used. Please see
page 5 for more details on the external EDID.
Link LED4
This LED activates when a valid link between the source and splitter is detected.
EDID Button5
This button will activate the onboard EDID. Press this button (the Int. EDID
should turn on and the Ext. LED should turn off) and reset the unit using the
Reset button (below) to initialize this EDID mode. To use an external EDID, press
the EDID button again (the Int. LED should turn off and the Ext. LED should turn
on) and press the Reset button to initialize this EDID mode.
Reset Button6
This button will reset the unit and initialize whichever EDID mode is currently
selected.