Filter
Top Products
6
To toggle between satellites when subscribing to multi-satellite programming—
The RoadTrip
™
SD and SDi will toggle between the
primary and secondary satellites for
either DISH
Network or DIRECTV. Both have programming on
more than one satelite. When a channel is se-
lected on the remote control and is not on the
satellite currently selected, the unit will automati-
cally toggle to the correct satellite.
Note: The RoadTrip
™
SDi will toggle while sta-
tionary or In-motion.
DIRECTV programming
1. DIRECTV receivers must be set for oval dish 2
sat selection to enable toggling between primary
101°W satellite and alternate 119°W satellite
only. (Consult receiver manual for procedure.)
After receiver is set for the correct dish selection,
when you request a channel located on a differ-
ent satellite, the unit will automatically toggle to
that satellite.
DISH Network programming (DISH 500)
DISH Network receivers must have the “SW42”
switch installed in order to toggle between the pri-
mary 119° satellite and the alternate 110° satellite.
(Consult your receiver manual for the procedure to
reach the “check switch” menu.)
NOTE: This “SW42 Switch” is a DISH Network
®
receiver setting, NOT a physical part.
To install the “SW42” switch:
1. Before turning on your
RoadTrip
™
system, make
sure that your satellite receiver and television are
turned on and your receiver is on the “point dish”
menu. (Consult your owner’s manual to reach this
menu.)
2. While the vehicle is stationary, turn on the
RoadTrip
™
system and wait for signal acquisition
on satellite 119°.
3a.
RoadTrip
™
SD. Wait for unit to acquire signal on
119°. Proceed to Step 4.
3a. RoadTrip
™
SDi. Unit MUST be Stationary! Af-
ter signal is acquired on satellite 119°, the system
will continuously track the signal for six minutes.
At the end of six minutes, the unit will enter sleep
mode (see page 5). Proceed to Step 4.
4. You now have six minutes to complete Check
Switch test. Consult your receiver manual for in-
NOTE: Be sure the “Superdish” and “Alternate”
boxes ARE
NOT checked.
!
Toggle: Your Winegard automatic
satellite dish will move from the
primary to the alternate satellite in
order to receive multi-satellite
programming.
structions on running the test. Be sure that
Superdish and Alternate are unchecked if appli-
cable. Onscreen options may vary by receiver.
5. During the Check Switch Test, the receiver will
begin checking the switch by toggling between
satellites. When this is completed, SW42 will ap-
pear on the screen. It will be at the top of the
screen, satellite designations will be below, show-
ing odd and even transponders. See illustration.
If a switch other than SW42 appears, or you
have an X in one of the boxes below the satel-
lites, repeat Check Switch Steps.
6. Your system is now set up to toggle between
satellites. It will automatically move to the correct
satellite when a channel is selected with your re-
mote control.
NOTE: Once these steps are completed, you
won’t have to perform this test again, unless
Check Switch was performed on another satel-
lite dish, such as a home dish.
Check Switch screen display
Install Summary
Input: 1 1 1 1
Satellite: 119 119 110 110
Polarity: Odd Even Odd Even
Status: Satellite reception verified
Superdish Alternate
Cancel Test Help
SW42
!
SW42 switch cannot be installed while
RoadTrip
™
SDi is in Tracking
Mode.