Filter
Top Products
5
FCC Compliance Statement
This equipment has been tested and complies with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy, and may cause harmful interference to radio
communications if not installed and used in accordance with the instructions. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the High Definition LCD TV and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the Westinghouse Service Center or an experienced radio/TV technician for
assistance.
FCC Warning
To assure continued FCC compliance, the user must use a grounded power supply cord
and the provided shielded video interface cable with bonded ferrite cores. If a BNC cable
is used, use only a shielded BNC (5) cable. Also, any unauthorized changes or
modifications not expressly approved by Westinghouse Digital Electronics will void the
user's authority to operate this device.
For tuner, according with UL60950-1
“Make sure that your CATV system installer has connected the Co-axial cable shield to the
grounding system of the building, as close to the point of cable entry as practical.
The common or earthed side of the connected (SELV) circuits and any accessible metal parts
should be connected to the screen of coaxial cable.”
The cable distribution system should be grounded (earthed) in accordance with ANSI/NFPA 70,
the National Electrical Code (NEC), in particular Section 820.93, Grounding of Outer Conductive
Shield of a Coaxial Cable.