Filter
Top Products
L3-16 User Guide
8
Chapter 2 – Quickstart Guide
We recommend reading this manual to get the most out of the L3-16. However, for a quick start to
setting up the L3-16 on your audio, follow these steps:
1. Insert the L3-16 Multimaximizer into your project, preferably as the last processor on the master
buss with no subsequent gain adjustment.
2. Play your audio, selecting a section with a high RMS level.
3. Experiment with various presets from the “Load” pull-down menu.
4. Select the Threshold/Out Ceiling Link control, located between the Input and Output meters,
and drag downward while watching the Attenuation meter.
5. Once the Attenuation meter registers gain reduction, listen carefully and continue to drag
downward until you hear degradation, distortion, or a reduction in level.
6. At this point, stop, and drag upward until the output sound is free of such degradations.
7. Set the Out Ceiling control to -0.2dBfs.
8. Set the IDR Quantize factor to match your designated medium.
9. Process your audio.