Filter
Top Products
When the Wadia 270 is turned on, it will automatically switch to a preset Resolution
Enhancement Mode. You can configure the Wadia 270 to switch to your preferred Resolution
Enhancement Mode. For more information, see Resolution Mode Select under
Operation.
There are three Resolution Enhancement modes:
MODE A:In this mode, the dither is processed using a high-pass dither filter.
MODE B: In this mode, the dither is processed using a low-pass dither filter.
OFF:
Resolution Enhancement disabled.
The factory setting is Mode A.
The same sequence is used to change any of the configuration settings:
1.
Press the ENTER key
(
+-I
)
on the remote control repeatedly until the desired
configuration screen appears.
2. Use the VOLUME UP
(
A+)
and VOLUME DOWN
(I-)
keys to select the desired
configuration setting.
3. Use the MUTE key to save your selection.
To avoid accidentally re-configuring a different Wadia component, hold the remote very close
to the display of the unit you would like to configure.
When you change the configuration the new setting will be saved even if you turn the power off.
For example, to configure Digital Out 1 to the OFF setting, use the following steps:
1.
Press the ENTER key until the “Configure Out 1
II
screen appears as shown below:
2. The factory setting is ON, so press the VOLUME UP or VOLUME DOWN keys to select
between ON and OFF. When OFF has been selected, the display looks like this:
3. The setting is not changed (or saved) until the MUTE key is pressed. NOTE:
If
you do not
press any key for ten seconds, the display
will
revert to the status screen.