9
To install the UHF-5805 to a 19” rack case, complete the steps below.
1. Attach mounting brackets to the UHF-5805 via the supplied mounting screws.
2. Align the UHF-5805 with the desired space in rack and slowly slide in, rear panel first.
3. While aligned, use rack case screws (not included) in the order shown below to stabilize the UHF-5805 in
its space, using the “X” rotation (numbered below) will ensure even tension and flush alignment.
Mounting
NOTE: Depending on your rack case design, it may be neces-
sary to allow for sufficient space for the antennas.
NOTE: Do not tighten screws firmly until all screws are in place.