Filter
Top Products
Troubleshooting
Problem
• There is no sound
• The vocals are distorted
• The music sounds distorted
• Music can only be heard from
on side of the speaker
• Vocals can only be heard from
on side of the speaker
• There is no Echo
• Vocal Cancel is not canceling
the vocals
Cause
• No power
• Music or Mic level is too low
• The wrong input channel is set.
• There are improper connection(s) in your
setup
• The mic volumes are set too high
• The microphone’s
tone controls are not
properly adjusted.
• The source music volume is too high
• The settings on the 7-Band EQ need to be
adjusted.
• The music level for one side is not turned
on/up.
• The microphone Pan control is set to one
side.
• The Echo On/Off button is switched off or the
Echo level control is turned down.
• The CD+G disc you are using is not Multiplex
formatted.
Solution
• Make sure the power cord is firmly
connected and the power is turned on.
• If using a surge protector/power strip, make
sure it is turned on.
• Turn up the music level controls on both left
and right EQ channels.
• Turn up the Individual Mic Volume controls
for each mic channel.
• Turn up the Mic Master Level control on the
front panel.
• Select the proper input source using the
Input Selector on the front panel.
• Make sure all the components are connected
correctly and that there are no defective
cables. Refer to the user’s manual for each
component for correct connection
instructions.
• Try turning down the Mic Master Level and
the individual volume controls.
• Set High and Low controls to the center and
the Mid control all the way to the right.
Then sing into the mic and adjust the Mid-
Sweep until the desired frequency of the
vocal is found. Then turn down the Mid EQ
and adjust the High and Low EQs until the
desired vocal sound is found.
• Turn down the music level controls on both
left and right EQ channels.
• Readjust the EQ sliders to the center and
then move each slide up or down to get the
desired music tone.
• Turn up the Left and Right music level
controls.
• Turn the microphone Pan control on the front
panel to the center position.
• Switch the Echo On/Off button to the ON
position and/or turn the Echo level control up.
• Use a CD+G disc that is Multiplex format-
ted.
11