Vestax PDX-a1 Turntable User Manual


 
[FEATUREs)
( SAFETY INSTRUCTIONS )
l The PDX-a1 is a high end performance turntable
designed Ior the beginners and the professionals with
the same basic quality as the beet selling turntable, the
PDT-5000.
l FAST STARTS BY HIGH TORQUE
Using high-torque direct motor, the in&Dal motor’
delivers l&g-cm start torque. The high-torque gives
quick starts that enables the platter to reach 33-H rpm
within 0.5 second.
1. Avoid placement of the unit where it will be
exposed to the direct sun light or where
ventilation is inadequate.
2.Avoid places where there is water or
humidity.
l FLOATING SUSPENSION TONEARM
The tonearm is mounted on the deck plate using a
floating suspension system with the drive moter.
Acoustic feedback is minimised by this advanced system.
l QUARTZ-PHASE-LOCKED CONTROL
The pitch is variable continuously by up to approximately
f 10% and returned automatically to the predertermined
speed (38-x or 45 rpm) by on/off switch even if the
pitch control is employed.
3. Don’t allow water or any foreign object to
get incidc of thia unit.
4. Place this unit away from heatemitting
appliances.
5. Place the unit on a stable, holizontal
position, where there is little or no vibration.
e NON-CENTER-CLICK PITCH FADER
Pitch fader has no center click, and it allows delicate
adjustment easily. The PDX-al features detachable pitch
control fader for eatic of replacement when it is worn
out.
6. Check the voltage rating of this unit before
connecting the unil to a power supply.
# MJNI LIGIIT FOR ILLUMINATING STYLUS(OI?TIONAL)
The PDX-al provids detachable small stylus illuminator
for illuminating the stylus tip during play for low-light
conditions.
l OTHER FEATURES
Quick stops are achieved with an electronic braking
7. fower supply cords should be routed so that
they are not likely to be walked on or
pinched by items placed on or against them,
paying particular attention to cords at plugs.
convenience receptacles, and the point where
they exit from the aplliance. Never take hold
of the plug or cord if your hand is wet, and
always be sure to grasp the plug body when
connecting or disconnecting.
system.
8. Never attempt repairs yourself ;
A. The power supply cord or the plug has
been damaged
Remote control jack is provided for controlling
START/STOP by other equipment like a fader start etc.
[BEFoRE)
#CAUTION : Never connect the AC power plug before
assembly has been completed.
l CHECKLIST OF PARTS :
This unit includes the f&wing par& ;
1. Turntable Unit
2. Turntable Platlor
6. Balance Weight
3. Slip Mat
7.45-rpm Adaptor
8. RCA Cable
4. Shell Weight
9. GND Cable
5. Headshell
B. iijeots have fallen or liquid has been
spilled into the appliance
or
C. The appliance has been exposed to rain
D. &, appliance has been dropped or the
enclosure damaged
E. Gie appliance does not appear to operate
normally or exhibits a marked change
in preformance.
9. Except for adjustments explained in the
operating instructions. do not attempt any
repairs yourself. Be sure to request service
from a qualified technician or your dealer or
nearest service center,
-l-