Filter
Top Products
T
his section addresses usage of your VDR subwoofer.
Remote Control
The features of the VDR remote control are listed below.
• POWER - This button forces your VDR unit into standby mode.
The woofer will not play and the LED will turn off. The unit will
remain in this mode until the POWER button is pressed again.
To fully deactivate (i.e. power down) the unit, turn off the power
switch on the back panel.
• MUTE - This button mutes the subwoofer. The light on the
subwoofer will blink slowly if the unit is muted. To unmute the
subwoofer, press the MUTE button again.
• PHASE - These buttons allow you to optimize the subwoofer
performance for the location and your listening position. Select
the switch position at which you hear the most bass. The light
will blink according to the following schedule:
0 degrees 1 blink
90 degr
ees 2 blinks
180 degr
ees 3 blinks
270 degrees
4 blinks
• LIGHT - If you wish, you can deactivate the blue front panel light on your VDR unit. To do this,
press the LIGHT button on your remote. The light will turn off. To reactivate the light, press
the LIGHT button again.
•
NIGHT -
Night mode limits the maximum output of the subwoofer for later night listening or
to be more considerate of close neighbors. Press the night button to turn the night mode
feature on or off. Night mode, when active, is indicated by the reduced intensity of the light.
• VOLUME Control - This control allows you to balance the output from the subwoofer to the
main speakers in your system. This control should be set to achieve similar volume level from
between both the main speakers and subwoofer. When pressing volume up or down, the
speed at which the power light blinks indicates subwoofer volume - the faster the blinking, the
louder the unit plays. after the volume blinking stops. the unit will blink out the actual volume
number. Slower blinks represent tens, and faster blinks represent ones. So, for example, if
the volume wer
e set at 34, after the rapid blinking stopped you would obser
ve three slow
blinks followed by four faster blinks, indicating a volume of 34.
Note: The volume can also be adjusted via the buttons on the back panel of the subwoofer.
These buttons have the same effect as pressing the up and down volume buttons on
your remote. The unit comes preset from the factory with the volume set at 30% of
maximum setting.
7
.
www.velodyne.com
VDR Series User’s Manual
Usage
Figure 2: VDR Remote.