Filter
Top Products
REAR PANEL C ONNECTIONS — DETAILED EXPLANATION
InstallAdvantage IA-400 Amp manual
www.chrysalisacoustics.com
8
The IA-400 amplifier is equipped with both speaker-level and line-level inputs. Use the RCA/Phono type “INPUT” jacks when connecting
from a pre-amp, signal processor, or line-level crossover. The “SPEAKER LEVEL INPUT” jacks connect directly to the speaker outputs of
an integrated amplifier or receiver. Your amplifier section will notice no additional loading effects when you use these inputs because of their
high impedance.
Note: Do not use both the RCA/Phono “INPUT” connections and “SPEAKER LEVEL INPUT” connections simultaneously.
About Low-Pass Crossovers
All of the IA-400 amplifier inputs sum the left and right channels together and the resulting signal is passed through an adjustable low-pass
crossover before being amplified. The crossover control allows you to adjust the upper limit of the subwoofer’s frequency response from 30 to
160 Hz. The subwoofer’s response will begin rolling off above the frequency you set this control to.The slope is 24 dB/octave.
You should set the crossover frequency to obtain a smooth and seamless transition from the subwoofer to the main speakers in your system.
If your main speakers are small with limited low frequency output, you may wish to choose a higher frequency (such as 100-120 Hz) than
you would with larger speakers which have greater low frequency output. The IA-400 amp’s crossover has a default of 80 Hz.
Most receivers and processors provide a menu option in which you can characterize main speakers as “large” or “small” speakers. This affects
the bass signals passed to the main speakers. We recommend in most cases setting the main speakers to “small,”despite their size and
frequency response characteristics, allowing all multi-channel base and LFE signals to be passed to the IA-400. This is because the powerful
400 watt IA-400 amp combined with the IA-IWS1 subwoofer you have purchased are more likely suited to low bass reproduction than your
amp and main speakers. With the burden of low frequency reproduction relieved, your speakers will exhibit better performance, and your
overall system performance will improve.
Disabling the Low-Pass Crossover (Subwoofer Direct)
If your receiver/processor provides a crossed-over signal to the subwoofer, you may want to bypass off the IA-400 amp’s low-pass crossover.
To do this, depress BOTH the Crossover UP and Crossover DOWN buttons simultaneously.The numeric LED will show indicating
that the low-pass crossover has been defeated. To reactivate the low-pass crossover, simply push the crossover UP or crossover DOWN
buttons.
A Word About Your Home Theater Receiver’s Crossover
and the IA-400 Amplifier’s Crossover
Your Chrysalis IA-400 amplifier is designed to operate using the full range audio signal for input when using the built-in crossover.
Many home theater processors/receivers have a “subwoofer out”jack that performs this same function and are designed to be used
with a powered subwoofer.
--