Univex AM-77 Stereo Amplifier User Manual


 
19
2a. Start-Up
1. Power On/Off
Press the ‘POWER’ rocker switch (R12) at the rear of the AMP to switch on mains power to the AM-77.
To switch the mains power OFF, press again and release. Always WAIT at least 30 seconds before switching
ON again. This is to enable the OptiMains® circuit to shutdown properly.
The display will light up to indicate the unit is switched on and ready for use. This should take just under 1 minute
as the OptiMains® circuit is verifying and the AM-77 is warming up.
The display should flash the message:
Optimising Supply
Voltage
The display will look like this:
Warming Up
45 s
The display will then show the remaining warm-up time.
Once powered
OFF: always wait
30 seconds
before switching
on again