Filter
Top Products
7
Installation
Installing the Battery Pack
1. Use a coin or screw driver to loosen the
screw on the cover.
2. Unlock both sides of the battery
compartment.
3. Open the cover.
4. Connect the battery pack (BT-446)
connector observing the correct
polarity (black and red wires) to the
jack inside the battery
compartment. Do not exert any
force on this connection. It could
cause damage to the battery or
handset.
The plastic connector will fit
together only one way. Once you
are certain that you have made a
good connection, then insert the
battery pack into the battery
compartment. Do not pinch the
wires.
5. Tighten the screw on the cover.
WHAM_UA466ZL UA01466ZA_0 9/20/02 12:50 PM Page 7