Uniden HS-150B Speaker User Manual


 
7
7.3. Using as a Floor Monitor
Notes
• When installing the speaker system on slippery floor,
put a non-slip mat under the speaker.
Do not kick or stand on the speaker system, as this
will damage the speaker.
The figure shows the HS-120 series.
7.4. Attaching the Supplied Rubber Feet
Attach the rubber feet in the case of speaker storage or
on-floor speaker installation.
Note
The rubber foot has a direction (back and forth).
Align the datum line on the rubber foot with the positioning
mark ( ) on the speaker unit as shown at right.
Rubber foot
(accessory)
Screw M6 x 30 (accessory)
Datum line
Positioning mark
7.5. Attaching a Handle
The speaker system comes with a handy carrying handle.
Attach the handle on the speaker's top surface.
Screw M6 x 30
(accessory)
Handle fitting bracket
(accessory)
Handle
(accessory)
8. EQUALIZING BY THE DIGITAL SIGNAL PROCESSOR
The speaker system is capable of providing high-efficiency and wide range reproduction without using an
equalizer, however more clear and dynamic sound quality can be reproduced by using our digital signal
processor and performing its settings as shown in the tables below.
[For the HS-120B and HS-120W] [For the HS-150B and HS-150W]
Filter Frequency (Hz) Gain (dB) Q
HPF (12 dB) 50 1.618
PEQ 580
-
5.0 3.134
PEQ 1500
-
4.0 4.318
PEQ 2100
-
3.0 4.938
PEQ 5500
-
2.0 3.134
PEQ 14000 +2.0 0.718
Filter Frequency (Hz) Gain (dB) Q
HPF (12 dB) 50 1.450
PEQ 500
-
4.5 1.850
PEQ 1250
-
3.0 3.450
PEQ 2900
-
5.0 1.850
PEQ 6500
-
3.0 1.414
PEQ 14000 +3.0 0.776