Plug-in Modules and Input Level SW Setting
Plug-in Modules
Balanced low impedance microphone preamp. module
(with presettable low-cut filter, high-cut filter and
gain controls)
Balanced low impedance microphone preamp. module
(with pressetable low-cut filter, high-cut filter
and gain controls, and remote control facilities)
Balanced low impedance microphone preamp. module
(with presettable low-cut filter and gain controls)
Balanced low impedance microphone preamp. module
(with presettable low-cut filter and gain controls,
and remote control facilities)
Unbalanced high impedance microphone preamp. module
(with presettable low-cut filter and gain controls)
Equalized mag. phono preamp. module
(with presettable gain control)
Unbalanced high impedance auxiliary preamp. module
(with presettable gain control)
Unbalanced high impedance auxiliary preamp. module
(with presettable gain control and remote control
facilities)
bridging transformer module
Balanced 600 line matching transformer module
Balanced paging input module
(with presettable gain control)
Signal tone generator module
(with presettable output level control)
1 kHz sine wave
Yelp and buzzer
One-tone chime and continuous one-tone chime
Model
No,
H-01
H-21
H-02
H-22
H-03
E-01
X-01
X-21
B-01
L-01
l-01
S-01
S-02
S-03
Input Level SW Setting
1V
(0dBv)
-
_
-
-
-
-
-
-
0
o
-
-
100mV
0
0
0
o
0
o
0
o
0
o
0
0
See PLUG-IN MODULES for details.
•
Two types of input terminals are provided on the rear for input
connections.
(1) 2P terminal (marked HOT, E)
It is provided for direct input (unbalanced, 10k ohms) without
using plug-in module. This terminal is directly connected with
a potentiometer inside.
(2) Plug-in module input
Select the desired module according to application.
•
Plug the module into INPUT PORT, sliding it between the guide
rails, and secure with two screws.
•
When INPUT PORT is not occupied, cover the PORT with the
blank panel, and secure it with screws.
•
Be sure that INPUT-LEVEL SWITCH is in the proper position
for the module used or the equipment connected to DIRECT
INPUT TERMINAL.
•
When the P-906A or P-912A is used in combination with a mixer
preamplifier or serves as an incremental power amplifier, normally
Input Connections
place INPUT LEVEL SWITCH in "1V (0 dBv)" position,
(—20dBv)
Balanced 10k
— 2 —