Filter
Top Products
25
RECORDING
Watching a TV program while
recording another
1)While recording, press
TV/VCR
to turn off
“VCR” indicator.
2) Choose another channel using the channel
selector on the TV.
Skipping unnecessary scenes while
recording
Press
PAUSE/STILL
to stop recording
momentarily. To resume recording, press
PAUSE/STILL
again.
Note
The VCR automatically shifts to the stop mode if the
recording pause mode continues for 10 minutes.
Basic Recording
1
Load a cassette with the safety tab attached.
2
Press
TV/VCR
so that the “VCR”
indicator appears in the VCR display.
3
Select a channel to record with
CHANNEL
on the VCR, or
CH/TRK
or
number buttons
on the remote
control.
If you see “L1/ L2” (For W-528/W-522 only), or “L” (For W-422 only)
in
the VCR display, press
ISELECT
so that the channel number appears.
• If you record cable channels via the cable box, make the output
channel number of the cable box or “L1”(For W-528/W-522 only),
“L” (For W-422 only) appear, depending on your connection.
(See pages 12 – 13).
4
Press
SP/SLP
to select the
recording tape speed.
SP: Suitable for general recording with
better picture and sound quality.
SLP: Suitable for tripling recording time, but with less picture and
sound quality than using the SP tape speed.
5
Press
REC
on the VCR, or
simultaneously press both
REC
on
the remote control.
Recording starts.
6
Press
STOP
to stop recording.
Recording off time setting
By setting the recording off time, the recording
stops and the VCR is turned off automatically.
While recording, press simultaneously both
REC
on the remote repeatedly to set the desired off
time.
Each time you press
REC
, each half-hour up to
about 4 hours appear cyclically.
Notes
• To cancel the recording in progress, press
POWER
on the VCR
.
VCR
VCR
VCR
REC
TIMER
S
VCR
L
TIMER
VCR
RECORDING
REC
TIMER
SLOW
PAUSE/STILL
REC TIMER
TV
VCR
POWER
I.SELECT
SP/ SLP
DISPLAY
TV VOL
COUNTER
PROG.
CANCEL
REMAIN/
RESET
COUNT
EJECT
CM SKIP
FF
REW
PLAY
ENTER
A.SELECT
1
2
3
6
5
4
100
9
87
0
STOP
5
I.SELEC
T
6
4
2
3
To record from other
connected equipment
In step 3, press
I.SELECT
to
switch the display as follows:
W-528/W-522 :
L1: To record via the LINE IN
1 jacks on the rear panel.
L2: To record via the LINE IN
2 jacks on the front panel.
W-422 :
L : To record via the LINE IN
jacks on the rear panel.
Recording a TV Program
This section explains the basic recording operation.
Preparation
• Select the video channel (3 or 4) or video input mode on the TV.
W-528 522 422 eng (25-29) 2/28/02, 2:31 PM25