Toshiba MMU-AP0151MH Cassette Player User Manual


 
16
3-7. Adjustment of Wind Direction
While the air conditioner stops, the horizontal flap (Up/Down air direction adjustment plate) automati-
cally directs upward.
While the air conditioner is in ready status for heating, the horizontal flap (Up/Down air direction
adjustment plate) directs upward. The swinging operation starts after heating ready status has been
cleared, but SWING is displayed on the remote controller even if the status is ready to heating.
How to set up the air direction
Push
SWING/FIX
button during operation.
ON / OFF
FAN
TEMP.
SWING/FIXTIME
MODE
VENT
UNITSET CL
FILTER
RESET
TEST
TIMER SET
In FAN operation
1, 2, 3 4
In all modes
Display when stopping the swing
Initial setup
Series of
operation
Fan/Heat
operation
Cool/Dry
operation
Unit No. 1-1No display Unit No. 1-2
Unit No. 1-4 Unit No. 1-3
1
Every pushing the button, the air direction changes.
In Heating operation
Set the horizontal flap (Up/Down
air direction adjustment plate)
downward. If directing it upward,
the hot air may not come to the
foot come to the foot.
In Cooling / Dry operation
Set the horizontal flap (Up/Down
air direction adjustment plate)
upward. If directing it downward,
the dew may fall on near the air
air outlet port or it drips.
How to start swinging
2
Push
SWING/FIX
button.
Set direction of the horizontal flap (Up/Down air
direction adjustment plate) to the lowest position
and then push
SWING/FIX
button again.
[SWING ] is displayed and the air direction
automatically changes upward/downward.
In case when one remote controller controls the
multiple indoor units, each indoor unit can be se-
lected and its air direction can be set up.
How to stop swinging
3
Push
SWING/FIX
button again during swinging of the
horizontal flap.
The horizontal flap can be stopped at the desired
position. After then the air direction can be again set
up from the uppermost position by pushing
SWING/FIX
button.
* While the horizontal flap is set downward in cool-
ing/drying operation, it does not stop.
If stopping the horizontal flap which directs down-
ward during swinging, it stops after moving to the
3rd position from the top position.
4
UNIT
To set up the air direction individually, push
UNIT
button to display each indoor unit No. in a group
control. Then set up the air direction to a displayed
indoor unit.
If there is no display, all the indoor units can be
operated collectively.
Every pushing
UNIT
button, the display exchanges
as shown in the figure.
Initial setup
Initial setup