Filter
Top Products
11
Troubleshooting…
No Sound?
Transmitter is not initialized
–
Re
-
check the
power
is
“on” at the transmitter and try changing
“channels a
t
the transmitter.
Check the audio signal source both to and from
the
transmitter. Try another cable to ensure
integrity.
Check the receiver amplifier, if used, is powered
“on”
at the mains, is not on “mute”, has no
headphones
attached and that the Channel
s
used for the
transmitter/ exterior speakers
(usually A or B) is in
operation.
Refer to the owners guide that came with your
receiver amplifier.
Check the “on” switch at the Remote Control to
make
sure the speaker is switched “on”.
Check the
volume control
on your
Remote
Control
is
switched high enough for volume
to
be heard.
Check the “Green” indicator light on your
speakers to
ensure they are receiving a signal.
Ensure you speakers are receiving power. Red
LED.
.
No Sound from one
speaker
Check the “balance” control on your receiver
amplifier
is “equal”
.
Check all connections and cable to and from, or
the
integrity of the transmitter source to the
inoperable
speaker.
Check the batteries or power source(s) to the
inoperable speaker.
Speaker
has
intermittent or rough
sound; the distance
of the remote
con
trol volume
controller becomes
nearer
Loudspeaker is flashing red or full light
–
the
battery
of the loudspeaker or remote control will
soon be out
of power. Please replace.
Check the “range” by temporarily bringing the
exterior
speakers closer to the tra
nsmitter
source.
Lift the transmitter height to see if this has any
effect.
One speaker
sounds distorted,
lower volume
Follow same procedure as above for “No
Sound”