Technicolor - Thomson RT2350BK Stereo Receiver User Manual


 
22
Advance Sound Control
Use a subwoofer to enjoy optimum sound.
Subwoofer Phase: Try both settings and select the
sound preferred.
Speaker distance: For optimum surround experi-
ence measure the distance between the speaker and
your favorite listening position.
1. Press SETUP once.
2. While the VFD display is showing L/R SML, press
UP/DOWN ARROW button to select.
3. Press OK button once to move to the next
speaker setting.
4. Repeat step 3 to set up the next speaker
5. When set up is done,
wait for 5 seconds to
automatically save your
settings or press any key
to save your selection
and set up mode.
Speaker Icons
The receiver shows you the speakers’ types and set-
tings on the display with the following icons:
Displaying Program Formats
When a digital source is playing, the receiver will
automatically switch to the proper surround mode
and indicates on the speaker icons on the right-hand
side of the display. (See diagram)
It is important to note, however, that not all Dolby
Digital sources are encoded with the full complement
of five channels plus LFE*. Speaker icons show how
many and which speaker you have enabled (See “Fine
Setting of the Speakers”) and the letters inside the
speaker icons show which channel is present in the
source information. For example, the diagram shown
means you have all the five speakers and subwoofer
enabled and the digital sources you played have five
channels plus LFE complemented.
* LFE stands for Low Frequency Effect. The indication
“LFE” appears if the digital source contains LFE infor-
mation. In this case, the bass signal will be delivered
to the subwoofer, offering more dynamic deep bass
sound effects. If the letter is flashing, the signal is
either too weak or just gone.
LS
RS
LFE
R
C
L
L
C
R
LS
RS
Large front speakers
Small front speakers
Large center speaker
Small center speaker
Large rear speakers
Small rear speakers
Subwoofer present
EQ DIGITAL I
N
ST / MO
OK
SETUP TEST TONE
SETUP TEST TONEMEMORY
OK
LS RS
LFE
R
C
L
TUNI
N
FM/AM
SOURCE
SOURCE
NOTE
• The sub-woofer selection will always be YES
when the main speakers are set to small
(SML).
• For the subwoofer phase setting, it will be
affected by how you locate the subwoofer.
Try both + and - settings and select the one
that has better bass effect.
• If your unit comes with speakers, always set
all speakers size to “small” to protect them
and optimize the sound quality.
• When left and right front speakers are set
to SMALL, center and surround speakers can
not be set to LARGE.