Filter
Top Products
22
Advanced Sound Control
Fine Setting of the Speakers
All the basic settings have already been pre-set for the
speakers included in the box.
Also, to make the surround sound more effective and
suit the acoustic conditions in your listening room, you
may need to delay the signal coming from some of the
speakers. Channel delay compensates for center or
surround speakers that are closer to the listening
position than the front speakers. You can make use of
the SETUP button to adjust the speakers’ relative
loudness.
Testing Speaker Loudness
You can listen to the loudness of the individual
speakers.
1. Press and hold LEVEL on
the remote control.
A short noise will be
heard in the speakers one
by one. The speaker
having the noise at that
moment will be shown in
the display.
2. To adjust the volume level of the test tone, turn the
VOLUME knob or press the + or -
buttons on the remote control to adjust the master
volume (if necessary).
Press LEVEL again and
press the Up or Down
buttons to adjust the
individual channel noise
level.
Adjust Individual Speaker Volume
1. To adjust individual speaker volume level, press the
LEVEL key on the remote control.
2. Continue to press the LEVEL button on the remote
control to select the channel to be adjusted, then
press the Up or Down buttons to adjust
the level.
You can adjust the master volume level by turning the
VOLUME knob or press the + or - buttons on the
remote control.
Advanced Setting
Factory defaulted Advance setting
indication from VFD
The receiver has defaulted the following distances:
Front speakers (FRNT) 5m
Center speaker (CNTR) 5m
Rear speaker (SURR) 3m
R/S
L/S
Rch
Cch
Lch
Front
Left
Rear
Right
Rear
Left
Front
Right
Center
B_DPL580 EN 4/16/04 12:53 PM Page 26