Filter
Top Products
Selecting Tuner Band
1. Press SOURCE to enter Tuner mode.
2. Press BAND/ INFO to select between FM MW
or LW Radio band.
Tuning to a Station
Press or to select frequencies. Press
and hold or to scan frequencies.
Using Presets
The tuner can be in either TUNE or PRESET mode.
• Press to toggle TUNE and PRESET
mode until “Program” lights on the display.
• Press or to access the previous or
next preset station.
Auto Preset Programming
(FM only)
Press and hold the BAND/ INFO button for 2
seconds to scan stations in FM band. The stations
will then be stored as preset channels. A
maximum of 32 stations can be stored. Beware of
your preset channels being erased accidentally
because the scanning and storing process is
automatic upon pressing the button. You can
stop the automatic scan by pressing any button,
but the erased stations cannot be recovered.
Manually Setting Presets
1. Press the button to enter TUNE
mode.
2. Press or to access the desired
frequency.
3. Press the PROG button once and the most
recently accessed program location flashes on
the display.
4. If a different program location is preferred,
press or to move to the desired
preset number (1-32).
5. Press PROG to store the selected frequency at
that preset.
Suppressing Stereo Signal
Press FM ST to toggle between FM mono and
stereo mode. (Remote Only) “STEREO” is
displayed in stereo mode.
Radio
Tips:
Under PRESET mode, press or
can only acess the preset stations. Manaully
tuning is not accessible in this mode.
FM02
Program
91.10MHZ
FM
AUTO
P:02
91.10MHZ
EN
15
CS196 EN 17/2/06 7:29 PM Page 22