Texas Instruments TPA102 MSOP Stereo Amplifier User Manual


 
2-1
Quick Start
Quick Start
The steps in this chapter can be followed to quickly prepare the TPA102 MSOP
audio amplifier EVM for use. Using the TPA102 MSOP EVM with the TI
plug-n-play audio amplifier evaluation platform is a quick and easy way to
connect power, signal and control inputs, and signal outputs to the EVM using
standard connectors. However, the audio amplifier evaluation module can be
used stand-alone by making connections directly to the module pins, and can
be wired directly into existing circuits or equipment.
The platform switch and jumper settings shown in Table 21 are typical for the
TPA102 MSOP EVM and will cause the TPA102 IC to shutdown/mute when
a plug is removed from platform headphone jack J10.
Table 21. Typical TI Plug-N-Play Platform Jumper and Switch Settings for the
TPA102 MSOP EVM
EVM JP6 JP7 JP8 S2 S3
TPA102 X Lo X Note 2 U5
Notes: 1) X = Dont care
2) Set S2 to ON when signal conditioning board is installed in U1; set S2
to OFF when no signal conditioning board is installed.
Topic Page
2.1 Precautions 22. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2.2 Quick Start List for Platform 23. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2.3 Quick Start List for Stand-Alone 24. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Chapter 2