Filter
Top Products
Recording operations
RQT5355
30
A
B
COUNTER
COUNTER
DISPLAY
A
A
COUNTER
RESET
RESET DISPLAY
C
1
3 5 2
46
DECK 1/2
Your attention is drawn to the fact that recording pre-recorded
tapes or discs or other published or broadcast material may
infringe copyright laws.
Before recording
(Deck 2 only)
Note
[SC-EH760]
You cannot record when [6CH DISCRETE INPUT] is selected.
(“ERROR” appears.)
Selection of tapes for recording
The unit automatically identifies the type of tape.
Normal position/TYPE I ✔
High position/ TYPE II ✔
Metal position/ TYPE IV ✔
»
A
To display the tape counter while recording
Press [COUNTER DISPLAY].
The counter is displayed for about 5 seconds.
To reset the tape counter
Press [COUNTER RESET].
³To display or reset the tape counter for deck 1, first press
[DECK 1/2].
»
B
Erasure prevention
The illustration shows how to remove the tabs to prevent recording.
To record on the tape again, cover as shown, being careful not to
cover the high position discrimination hole.
Volume, sound quality and surround effects
These have no effect on recording. Sound quality and surround
effects are automatically set to flat when recording.
»
C
Erasing recordings
1 Press [INPUT SELECTOR] to select “TAPE”.
2 Insert the recorded tape into deck 2.
3 Press [DOLBY NR] so the “ëNR” indicator goes out.
4 Select the reverse mode.
5 Press [´ REC PAUSE].
6 Press ["] or [!].
Side A
Tab for side “B”
Tab for side “A”
To re-record
Normal tape High-position tape
Discrimination hole