Teac T-R670AM Stereo Receiver User Manual


 
Connecting Antennas (2)
Connection with an Amplifier
10
ENGLISH
AM (MW) Antenna
> AM Indoor Loop Antenna
A high-performance AM loop antenna provided with the tuner is
sufficient for good reception in most areas.
Snap the supplied loop antenna into the hinge on the rear of the
unit, and connect the wires running out the loop antenna to the
AM terminals, as shown.
When you actually try listening AM programs later, you may
want to turn the loop antenna on the hinge for the best possible
reception.
> AM Outdoor Antenna
If the AM loop antenna provided does not deliver sufficient
reception (because you are too far from the transmitter or in a
concrete building, etc.), it may be necessary to use an outdoor
AM antenna.
Use an insulated wire more than 15 ft (5 m) long, strip one end,
and connect this to the terminal as shown.
The antenna wire should be strung outdoors or indoors near a
window.
For better reception, connect the GND terminal to a reliable
ground.
Note:
< Even when using an outdoor AM antenna, do not disconnect
the AM loop antenna.
AM Loop Antenna (provided)
Antenne cadre AM (MW) (fournie)
Antena de cuadro de AM (MW)
(incluida)
AM Outdoor Antenna
Antenne AM (MW) extérieure
Antena externa de AM (MW)
Using appropriate audio cables connect the LINE OUT "L" jack to
the Line In Left jack on your amplifier, and the LINE OUT "R" jack
to its Line In Right jack.