Filter
Top Products
3
CAUTION:
<
Switch off the power to all equipment before making
connections.
<
Read the instructions of each component you intend to use
with this unit.
<
Be sure to insert each plug securely. To prevent hum and
noise, avoid bundling the signal interconnection cables
together with the AC power cord or speaker cables.
Connection
REMOTE CONTROL SELECTOR
If the REMOTE CONTROL jack is connected to the A-
H300mk
III, select ‘SYSTEM’. When operating the remote
control unit provided with the A-H300mk
III, point it towards
the remote sensor of A-H300mk
III.
If the REMOTE CONTROL jack is NOT connected to the A-
H300mkIII, select ‘SINGLE’.
LINE OUT jack
Analog 2-channel audio signal is output from this jack.
Connect this jack to the TUNER jack of the amplifier (A-
H300mk
III) with an RCA cable.
Make sure to connect:
white plug q white jack (L: left channel)
red plug q
red jack (R: right channel)
DIGITAL OUT terminal
DAB’s digital audio signal is output from this terminal. If you
want to record digitally, or decode the signal using an
external digital decoder, connect to the digital input
terminal of a digital recording device or a decoder using a
commercially-available optical digital cable.
<
When inserting the plug of the optical cable, the protective
shutter of the terminal will open and you should hear it click
into position when fully inserted. Be careful that you do not
force the plug, because this could result in damage to the
protective shutter, the cable, or the unit itself.
AC Power Cord
After all other connections are complete, connect the plug
to the AC wall socket.
Be sure to connect the power cord to an AC outlet which
supplies the correct voltage.
Hold the power plug when plugging or unplugging the
power cord.
E
D
C
B
T-H300DABmkIII
Amplifier (A-H300mkIII)
A
B
D
C
E
REMOTE CONTROL jack
If you have TEAC A-H300mkIII, convenient system control
operations are available:
• When you tune in a station, the input selector of the A-
H300mk
III is set to ‘TUNER’ automatically.
• You can use the system remote control unit RC-957 or RC-
1091 (provided with A-H300mk
III) to operate this unit.
Connect the REMOTE CONTROL jack to the REMOTE
CONTROL jack (A or B) of A-H300mkIII or PD-H300mkIII
with the provided remote control connection cord.
Read the owner’s manual of A-H300mk
III for details.
Note:
The remote control unit is not provided with this unit.
A