Filter
Top Products
5. Specifications English
TASCAM CD-X1500 DUAL CD PLAYER 21
Disc type: 8cm / 12cm CD
Number of channels: 2-channel
Resolution: 16-bit
Sampling frequency: 44.1kHz
Analog output: RCA pin jack
Output impedance: <1kohm
Maximum output level: +6dBV
Digital output: Coaxial
Format: IEC60958 Type II
Voltage requirements
USA/Canada: 120V AC, 60Hz
UK/Europe: 230V AC, 50Hz
Australia: 240V AV, 50Hz
Power consumption: 27W
Peak inrush current: 0.9A
Applicable electromagnetic
Environment: E4
Dimensions (W x H x D mm)
Main unit: 482 x 94 x 272
Remote control unit: 482 x 88 x 83
Weight
Main unit: 5.7kg
Remote control unit: 1.8kg
The following values are applicable when key and
tempo values are set to 0.
Frequency response: 20 – 20kHz,
+0.5/-1.0dB
Dynamic range: >95dB
S/N ratio: >95dB
Total harmonic distortion: <0.01%
Error Messages
Err 01 TOC Read error - the disc's Table of Contents cannot be read within 20 seconds - try with another
disc or remove and clean the existing disc before replacing it
Err 02 GFS error – GFS signal cannot be detected within five seconds - try with another disc or remove
and clean the existing disc before replacing it
Err 03 Focus error - after repeating the attempt eight times to focus, an error still occurs - try with another
disc or remove and clean the existing disc before replacing it
Err 04 Sub-Q error - the sub-Q code cannot be detected (twice within five seconds) - try with another
disc
Err 05 Loading error - the open or close operation cannot be completed, even after retries, or there is an
internal error - make sure that there are no obstructions preventing the tray's operation
Err 06 Sled error - an internal drive error - try turning the power off, waiting a few seconds, and turning
it on again
Err 07 Error in communication between decks - try turning the unit off, waiting a few seconds, and
turning it on again
Err 10 S-DRAM error - an internal S-DRAM error - try turning the power off, waiting a few seconds,
and turning it on again
If any of the numbered error messages occur, try using another disc.
If the errors continue with a number of discs, turn the unit off, wait for a few seconds, and turn it on again.
If the errors still continue or other error occurs, contact your TASCAM distributor for repair.