Filter
Top Products
TANDBERG 8000 MXP
12
Remember that there should be a gap on each side of the monitor.
Be careful when removing the plastic film. Do not pull the plastic off the monitor at a 90º
angle as this may damage the screen. Instead you should remove the plastic film by pulling
it parallel with the screen at a 180º angle.
Installing the camera
Take the camera and remove the plastic backing from the double-sided pads on the base of the
unit. Place the camera centrally on top of the monitor, in line with the front of the screen. The
camera should be aligned with the front edge of the monitor to ensure that the IR-sensor in the
camera can pick up signals from the remote control.