Filter
Top Products
OFF
ON
A/C LINE FUSE
SLO BLO
8 AMP
120 VOLTS
50/60 HZ
960 WATTS
LEFT SPEAKER
RIGHT SPEAKER
L SPKR
FUSE
10 AMP
R SPKR
FUSE
10 AMP
SPEAKER OUTPUTS
350W X2
STEREO
1
2
1
2
EFFECTS
BALANCED
OUT
STEREO
TO
TUNER
INPUT
X OVER
OUT
RETURNS
LEFT
XLR PAD
SEND
RIGHT
MONO
HI
LOW
PULL GND LIFT
MIN
LINE
MAX
DIRECT
BRIDGE MONO
800W
FUSE
FUSE
FUSE
SM-900 Stereo Mode Operation Diagram
Power Amp Assign Switch
set to “Stereo” position.
Note: When the power amp assign switch is set to the “Stereo” position, only the right and left Speakon
output jacks or left and right 1/4” output jacks may be used. Do not use the center Speakon jack as it is
provided for Bridge/Mono operation only.
SM-900 Power Output Ratings
Stereo Mode (per side)
400 watts @ 4 Ohms
240 watts @ 8 Ohms
144 watts @ 16 Ohms
(minimum load = 2 Ohms)
Speaker 1 = 8 Ohms
This example shows two 8 ohm speaker enclosures, each connected
to one side of the stereo power amp for a total load of 8 ohms per
side. Although the minimum impedance that the SM-900 is designed
to drive safely in the Stereo Mode is 2 ohms (per side), 4 ohms per
side or greater is recommended. Connecting multiple enclosures that
have a combined total impedance of less than 2 ohms per side may
result in damage to your amplifier.
The following cabinet configurations can be used:
• one 2 ohm enclosure (per side)
• one 4 ohm enclosure (per side)
• one 8 ohm enclosure (per side)
• two 4 ohm enclosures (per side)
• two 8 ohm enclosures (per side)
Speaker 2 = 8 Ohms
18 • SM-900 USER GUIDE