Sunfire TGR-401-230 Home Theater System User Manual


 
User's Manual
12
CHAPTER 1
6. HDMI
Use these to connect any HDMI
components you may have in your
system. Three are inputs, and
one is an output to your HDMI-
equipped TV. This supports 1080p
and HDMIv1.3a sources. No on-
screen-display or audio decoding
inside the TGR-401 is available
from the HDMI inputs. Always
connect a separate digital audio
input cable when using HDMI.
7. Preamp Outputs
These line-level audio outputs
allow you to use external ampli-
¿ ers to power your loudspeakers.
There are outputs for L, R, C,
LS1, RS1, LS2, RS2, LB, RB, and
SUB.
8. Speaker-level Outputs
These speaker-level audio out-
puts connect to the input posts of
your loudspeakers.
9. 8-CH Inputs
These analog audio inputs can
connect to the output of an ex-
ternal surround processor, or a
source component such as DVD-
Audio, SACD, or a DVD player
Rear Panel Fea tures
1. AM Antenna
These con nec tions are for the
supplied AM loop antenna.
2. FM Antenna
The supplied FM antenna ¿ ts this
“F-type” coaxial connector. Other
antennas can be ¿ tted for im-
proved re cep tion.
3. SIRIUS Connection
This connection is provided for
the optional SIRIUS tuner kit
(SC-H1P1). This consists of an
antenna for picking up satellite ra-
dio transmissions, and a tuner unit
that connects here. The connec-
tion allows left and right audio and
control data to enter the TGR-401.
The OSD menus of the TGR-401
allow you to select your favorite
SIRIUS Satellite radio stations as
presets for easy recall. See page
63 for more details.
4. Audio/Video
These audio, composite-video
and S-video inputs con nect to the
outputs of your audio video com-
po nents. When these inputs are
selected, the audio will be heard
in your system, and the video will
be seen on the TV screen.
Fixed audio output is available, for
example for stereo recording to
a tape player, independent of the
TGR-401 volume. A stereo audio
Zone 2 output is also available.
S-Video and composite video out-
puts are available for monitoring,
as well as a composite video out-
put for Zone 2. Note that the video
sources you would like to play
in Zone 2 must use composite
video. (There is no video up/down
conversion in Zone 2.)
5. Component Video
These inputs con nect to the
component-video outputs of your
video sources if they have this
capability. When these inputs are
se lect ed, the TGR-401 will au to -
mat i cal ly route any video signals
going into these jacks to the com-
ponent video outputs. Note that
component video provides the
best picture compared to compos-
ite or S-video.
If your TV Monitor has component
video inputs, connect them to the
TGR-401's component outputs.
The TGR-401 can also up-convert
composite video and S-video from
the other inputs.
4367 8
2
910111213 15 1814 16 17
1
5