Filter
Top Products
User's Manual
26
GUIDE MENU
MODEMODE
EXIT INFO
SYSTEM
+10
POWER
31
64
97
ENTDIS
M3M1
2
5
8
0
M2
PAG E
FAV
MAIN
OFF
VOL CH
MUTE
PREV
CH
CD
AUDIO
MAIN
TAPE
AUX
ZONE2
TGIV
DVD
VCR
SAT
TV
CABLE
CHAPTER 3
1. Press the remote's MAIN button
to make sure the display is on the
main display menu.
2. Press the TGIV de-
vice button to set
the remote to oper-
ate your TGIV. The
display chang es
to show the TGIV
input se lec tions:
3. Press PAGE to
reach page 2,
which shows the
PRO LOGIC-IIx,
PAR TY, STE REO,
HO LO GRAM, and
the trims for center,
sur rounds, and sub.
On the right is '+'
(in crease level) and
on the left is '-' (de-
crease level).
4. The fol low ing but tons with fi xed la-
bels are also pro grammed: Pow er,
Vol ume up, down and Mute. The
number pad accesses the tuner
presets directly, and CH+/- steps
through them. DIS is the +10 func-
tion, and ENT is station enter. The
MODE buttons either side of the
joystick, allow you to select the dif-
ferent surround modes.
ZONE 2
Note: Zone 2 must fi rst be enabled
using the OSD (see page 36), or
these controls will have no effect.
Zone 2 can be turned on even if
the Main Zone is off.
See page 47 for more Zone 2 details.
1. From the main
display menu,
press the ZONE2
device button to
access features
of the second
zone. Page 1
shows the input
selections.
2. The hard buttons operate Zone 2,
such as Power, Volume, Mute, and
the Tuner controls and presets.
Operating the TGIV with the Remote
MAIN
PAGE
TGIV
ZONE 2
Previous Mode
Next Mode
Full-page On Screen
Display (OSD)
Momentary status and
information display
OSD Exit
Use the Joystick to navigate
through the OSD (when active)
Hold down MAIN and
ENT for a few seconds
to enter the SETUP
mode. See next page.
ENT
3. Page 2 shows
Zone 2 on/off,
Zone 1 on/off,
and balance left/
right.