Filter
Top Products
B A C K PA N E L
28. Headphone output: Standard 1/4” headphone output connector.
29. Session/Mic switch: Used to assign the Session/Mic fader to either the
Session input or the MIC input.
30. Microphone input: 1/4” connector for connecting a microphone.
31. Phono Inputs: Phono level inputs for channels 1 and 2. Do not plug line
outputs into phono inputs.
32. Line inputs: Line level inputs for channels 1 and 2.
F R O N T PA N E L
33. Headphone output: Standard 1/8” (mini jack) headphone output
connector.
34. Reverse indicator LED’s: The LED’s indicate the status of the fader
reverse functions. The respective LED lights up when a fader is reversed.
35. Line fader curve switch: Three-position switch selects between a sharp,
mid and long fade for the corresponding line fader.
36. Cross fader curve switch: Three-position switch selects between a sharp,
mid and long fade for the crossfader.
37. Headphone output: Standard 1/4” headphone output connector.
BACK PA N E L
19. AC IN: Input connection for the included power supply.
20. Power switch: Turns the mixer on or off.
21. Balanced Master output: TRS balanced (1/4”) connectors are typically
used to connect to a P.A. mixer or an amplifier for live performances or a
recording console for recording.
22. Unbalanced Master output: RCA connectors are typically used to connect
to a home stereo or to another mixer with RCA inputs for practicing or team
routines. Several SA-5’s, can be daisy chained from this output via the
session input (25).
23. Master Trim: Controls the sensitivity of the Master output. Great when an
additional boost or cut is needed.
24. REC: The record output is not affected by the Master volume control.It can
be used to record to a computer, CD, MD, & tape recorder, even while the
master volume is turned down.
25. Phono Trim: Used to adjust the gain of the phono pre-amp. Use this knob
to control the sensitivity of the gain faders.
26. Ground connector: Connects to the turntable ground connector to
eliminate electrical hum. Ground cables usually supplied with turntables.
Some newer turntables such as the Stanton STR8-150 do not require a
ground cable because they are grounded internally.
27. Session Input: This extra line level input is controlled by the session level
fader (1) when the Session/Mic switch (27) is switched to session (the up
position). It can be used as an extra line input or as a session input for
team routines.
19
20
21
24 31 32 3231
2726
25
28
29
30
2622 23 25
34 34 34
35
36 35
33
37