Filter
Top Products
GainStation 8
13
IMPED. Ω
This 3-way switch allows you to select between three input
impedances for the Mic Input. In general, higher impedances
increase levels and emphasize high frequencies, while mids and
bass frequenices are dampened. Conversely, a lower impedance
causes lower levels and emphasizes bass and mid frequencies.
The Imped. Ω-Wert does not have to be equivalent to the output
impedance of the microphone. We recommend the highest
impedance setting as starting position (10.000 Ohm). Now it
must be evaluated acoustically, if lower settings are delivering
better results.
PHANTOM
The GainStation 8 provides 48 Volt phantom power for micro-
phones requiring external current (generally condenser micro-
phones). Such microphones are dependent upon a clean, consis-
tent and noise-free power supply for optimal operation and
audio quality. The GainStation 8 continuously delivers precisely
48 V and a maximum of 14 mA, which will power all micro-
phones.
IMPORTANT NOTE: All microphones with balanced, ground-free
outputs, including tube microphones, can be used with the
phantom power activated. First connect the microphone to the
GainStation 8, then activate the phantom power. When finished,
first deactivate the phantom power and wait at least 30 seconds
before disconnecting the microphone to allow residual current
to discharge.
Phantom power should only be activated when using micro-
phones that require it. Please be sure to deactivate phantom
power with all other microphones. Unbalanced microphones
may only be used with phantom power deactivated.
The 48V LED illuminates to indicate activated phantom power.
When deactivating phantom power, it can take several seconds
for the LED to go out, since the 48 V current dissipates rather
slowly. When changing microphones, you should wait until the
LED is completely dark before re-patching.
Control elements
1.2k
200
IMPED. Ω
10k
PHANTOM
Off48V