Filter
Top Products
10
GainStation 8
Rear panel/connections
MIC INPUT
Dynamic, condenser or tube microphones can be connected to
the Mic Input. The 48 V switch provides the phantom power
necessary for some microphones (see also „Control elements/
Phantom“ on page 13).
The MIc Input can also be used as a balanced connection for
professional audio equipment with a maximum output level of
+20 dBu. The Clean Gain already delivers 10 dB of minimum
preamplification, this leaves you with 4 dB of headroom.
IMPORTANT NOTE: Always switch the phantom power (48 V)
off before connecting anything other than phantom-powered
condenser microphones.
INSTRUMENT/LINE INPUT
The Instr. In is for electric guitars and basses or other high-impe-
dance, line-level signals such as keyboards, samplers, drum
machines etc. with unbalanced outputs. If a balanced connector
(TRS) is inserted, the ring of the plug is automatically connected
to the ground to ensure proper unbalanced operation.
ANALOG OUTPUTS 1/2
The preamplified output signal is fed to the balanced Analog
Outputs. Since the XLR and 1/4" TRS connectors are wired in
parallel, an unbalanced connection at one connector will cause
the other connector to operate unbalanced, e.g. if a mono 1/4"
plug is inserted into the 1/4" jack, the corresponding XLR socket
will also operate unbalanced.
IMPORTANT NOTE: The output connectors can deliver an output
level of up to +34 dBu. Please ensure that all other equipment
can handle these levels to prevent possible damage.
MIC
INPUT
PUSH
INSTR. IN
(UNBAL.)
OUT 2
(BAL. )
OUT 1
(BAL. )