Filter
Top Products
SPECIFICATIONS
Speaker Type:
Tweeter:
Woofers:
Impedance:
Sensitivity:
Frequency Adjustments:
Frequency Response:
Power Handling:
Cut Out Dimensions (W x H):
Dimensions (W x H x D):
LIMITED LIFETIME WARRANTY
SpeakerCraft Inc. warrants to the original retail purchaser only that this SpeakerCraft product will be free from defects in materials and workmanship, provided
the speaker was purchased from a SpeakerCraft Authorized Dealer.
Defective products must be shipped, together with proof of purchase, prepaid insured to the SpeakerCraft Authorized Dealer from whom they were pur-
chased, or to the SpeakerCraft factory at the address listed on this installation instruction manual. Freight collect shipments will be refused. It is preferable
to ship this product in the original shipping container to lessen the chance of transit damage. In any case, the risk of loss or damage in transit is to be borne
by the purchaser. If, upon examination at the Factory or SpeakerCraft Authorized Dealer, it is determined that the unit was defective in materials or work-
manship at any time during this warranty period, SpeakerCraft or the SpeakerCraft Authorized Dealer will, at its option, repair or replace this product at no
additional charge, except as set forth below. If this model is no longer available and can not be repaired effectively, SpeakerCraft, at its sole option, may
replace the unit with a current model of equal or greater value. In some cases where a new model is substituted, a modification to the mounting surface
may be required. If mounting surface modification is required, SpeakerCraft assumes no responsibility or liability for such modification. All replaced parts and
product become the property of SpeakerCraft Inc. Products replaced or repaired under this Warranty will be returned to the original retail purchaser, within
a reasonable time, freight prepaid.
This Warranty does not include service or parts to repair damage caused by accident, disaster, misuse, abuse, negligence, inadequate packing or shipping
procedures, commercial use, voltage inputs in excess of the rated maximum of the unit, or service, repair or modification of the product which has not been
authorized or approved by SpeakerCraft. This Warranty also excludes normal cosmetic deterioration caused by environmental conditions. This warranty will
be void if the Serial Number on the product has been removed, tampered with or defaced.
This Warranty is in lieu of all other expressed warranties. If the product is defective in materials or workmanship as warranted
above, the purchaser’s sole remedy shall be repair or replacement as provided above. In no event will SpeakerCraft be liable
for any incidental or consequential damages arising out of the use or inability to use the product, even if SpeakerCraft Inc.
or a SpeakerCraft Inc. Authorized Dealer has been advised of the possibility of such damages, or for any claim by any other
party. Some states do not allow the exclusion or limitation of consequential damages, so the above limitation and exclusion
may not apply.
All implied warranties on the product are limited to the duration of this expressed Warranty. Some states do not allow limitation
on the length of an implied warranty. If the original retail purchaser resides in such a state, this limitation does not apply.
SpeakerCraft offers a variety of accessories to make your installation of this and other SpeakerCraft products easy, economical, and professional.
Contact your authorized SpeakerCraft Dealer for more information. For technical inquires, please call 1-800-448-0976 or e-mail us at techsupport@
speakercraft.com. We are available to assist you every weekday, except holidays, between the hours of 7:00 a.m. and 5:00 p.m. PST.
AIM LCR3 One
2-Way In-Wall
Pivoting 1" Silk Dome
Two 3" Injection Molded
Graphite Cones
8 ohms compatible
85dB 1W/1m
None
80Hz - 20kHz
60 watts (undistorted)
4
3
⁄4" x 9"
(120.650mm x 228.600mm)
5
3
⁄4" x 10" x 2
7
⁄8"
(146.050mm x 254.000mm x 73.025mm)
AIM LCR3 Three
2-Way In-Wall
Pivoting 1" Aluminum Dome
Two 3" Aluminum Cones
8 ohms compatible
86dB 1W/1m
Front-Mounted 2-Position
Treble Adjustment Switch
78Hz - 20kHz
60 watts (undistorted)
4
3
⁄4" x 9"
(120.650mm x 228.600mm)
5
3
⁄4" x 10" x 2
7
⁄8"
(146.050mm x 254.000mm x 73.025mm)
AIM LCR3 Five
2-Way In-Wall
Pivoting 1" Aluminum
Magnesium Dome
Two 3" Kevlar Cones
8 ohms compatible
86dB 1W/1m
Front-Mounted 2-Position
Treble Adjustment Switch
60Hz - 20kHz
60 watts (undistorted)
4
3
⁄4" x 9"
(120.650mm x 228.600mm)
5
3
⁄4" x 10" x 2
7
⁄8"
(146.050mm x 254.000mm x 73.025mm)
LIT70800(rev2)
940 Columbia Ave., Riverside CA 92507 | USA (800) 448 0976 Fax (951) 787 8747 International +1 951 787 0543 | www.speakercraft.com
In our attempt to constantly improve our products, features and specications are subject to change without notice.
PRINTING INSTRUCTIONS: AIM LCR3 MANUAL - INK: BLACK - MATERIAL: 80lb Gloss - SIZE: 8.500” x 11.000”