Soundstream Technologies MC-300 Stereo Amplifier User Manual


 
PROTECTION CIRCUITS
-
Your amplifier is protected against both overheating and
short circuits. Because of the “soft’ thermal protection (see
the Design Features section on page
3)
it is highly unlikely
that the amplifier will shut off because of thermal overload.
If your amplifier shuts down, turn off the system, wait for a
few moments, and turn the system on again.
SERVICE
Your Soundstream amplifier is protected by a limited war-
ranty. Please read the warranty enclosed with the product.
SPECIFICATIONS
Power output:
2-channel
150 watts continuous per channel
x
2 into 4 or
8
ohms, 20 Hz 20
kHz
3-channel
150 watts continuous mono
into 4 or
8
ohms, 20 Hz
-
20
kHz
75 watts continuous per channel
x
2 into 2 or 4 ohms, 20 Hz 20
kHz
4-channel 75watts continuous per channel
x
4 into 2 or 4 ohms, 20 Hz
-
20
kHz
Total Harmonic Distortion <O.l%, 20 Hz 20
kHz
at full rated power
into 2, 4 or
8
ohms
Signal-to-Noise Ratio
~100
dS
Damping Factor
._.............__......
>200
IHF Dynamic Headroom 3
dS
Maximum Current Draw 45 amps
Idle Current Draw 2.5 amps
Input Sensitivity 250
mV
2.5 V
continuously variable
LSE .._..................... 35Hz-280Hz.
infinitely variable
Dimensions . . . . . . . . . . . . . . . . . . ...14-l/5” W
x
2.3/5”
H
x
10” D
with bottom plate
14-l/5”
W x
2-3/Y
H x
6-112”
D
heat sink