Filter
Top Products
An&a
and A4
Sarnde
System
Complete
Sys
feti
while using a Factory
Radio
RADIO
Spmkrr
Lwcl
O”,
Front
Speakers
Troubleshoo
thy
PROBLEM
No Sound and power LED is not
lit
No sound, power LED is lit
Amplifier output cuts on/off
repeatedly
Repeatedly blow amp fuse;
frequent activation of Trident
protection or Smart Power
Supply Circuit
CAUSE
1. No power or ground at the
amp
2. No remote turn-on signal
3. Blown fuse near the battery
1. No signal input
2. Speaker leads may be
shot-ted
3. Speaker leads may be
referenced to ground
1. Speaker output may be
shorted to ground.
2. Speaker leads may be
shorted to each other. Check
continuity with a volt meter.
1.
Speaker or leads may be
shot-ted
2. Amplifier load may be too low
3. Verify adequate amp
ventilation
/
NOT’:
If
you experience blown main power supply fuses, ii is
)
likely
fhat
the amplifier is seeing a dead short, either in the
speaker wire or in the speaker itself.
Rectify
the
problem before
blowing
multiple
fuses! DO NOT increase values beyond the
original fuse vafue! Doing so
will
void your warranty and may
damage your amplifier.
Service
Your Soundstream RUBICON amplifier is protected by a limited warranty.
Please read and send in the enclosed warranty card.
21