Filter
Top Products
7
GB
Getting Started
VCR
Use the function buttons (TV/LD, CD, MD/TAPE etc)
to select the VIDEO AUDIO OUT signal. You can record
this audio signal by connecting a recording component
such as a cassette deck (to the VIDEO AUDIO OUT
jack).
DVD player/AC-3 decoder
What cables will I need?
• Audio cable (not supplied) (1 for each 5.1 CH/DVD
FRONT and REAR jacks)
• Monaural audio cable (not supplied) (1 for each 5.1
CH/DVD CENTER and WOOFER jacks)
• Video cable (not supplied) (1 for the 5.1 CH/DVD
VIDEO IN jack)
You can play decoded Dolby Digital AC-3 soundtracks
through the speakers connected to the amplifier.
If you have a Dolby Digital AC-3 decoder you can
amplify a decoded Dolby Digital AC-3 soundtrack with
the following connections.
Where do I go next?
Go on to the next section to connect the speakers.
White (L)
Red (R)
White (L)
Red (R)
Black Black
Yellow Yellow
Receiver
VCR
AUDIO IN
VIDEO
VIDEO IN
AUDIO
OUTPUT
VIDEO
AUDIO
INPUT
VIDEO
AUDIO OUT
L
R
VIDEO OUT
L
R
FRONTREARCENTER
WOOFER
VIDEO
PRE OUT
5.1 CH/DVD
FRONT REAR CENTER
WOOFER
VIDEO
L
R
Receiver
Dolby Digital AC-3
decoder, etc.
Speaker System Hookups
Overview
This section describes how to connect your speakers to
the receiver. Although front (left and right) speakers
are required, centre and rear speakers are optional.
Adding centre and rear speakers will enhance the
surround effects. Connecting an active woofer will
increase bass response. For specific locations of the
terminals, see the illustration below.
For optimum surround sound effect, place your
speakers as shown below.
What cords will I need?
Speaker cord (not supplied) (1 for each speaker)
Twist the stripped ends of the cord about 15 mm (2/3 inch).
Be sure to match the speaker cord to the appropriate
terminal on the components: + to + and – to –. If the cords
are reversed, the sound will be distorted and will lack bass.
45°
WOOFER
SPEAKERS
FRONT A
SPEAKERS
CENTER
SPEAKERS REAR
60 - 90 cm
Rear speaker
(+)(+)
(–)
(–)
SPEAKERS
FRONT B
(continued)