Filter
Top Products
8
EN
Getting Started
4 Connect the second amplifier to SURROUND
OUT CENTER, and connect the center speaker to
this amplifier.
The center signal is output from the SURROUND
OUT CENTER terminal.
5 Remove the cover on the POWER SWAP selector
and set the selector to the SWAP position.
After you have completed the setting, reattach the
cover to the selector and plug in the power cord.
To adjust the volume
Set the volume control of the separate amplifiers to the
maximum position and adjust the volume level with the
volume control of the receiver.
Notes
• For best results, we recommend using a pair of equivalent
amplifiers to boost front and center speaker output. You
can, however, connect the center speakers to the CENTER
SPEAKER terminals if you only have one additional
amplifier.
• Do not use the terminals labeled CENTER SPEAKER or
REAR SPEAKERS if you connect two additional
amplifiers. Make connections as shown above.
• If you want to turn off the power swap function, set the
POWER SWAP selector to the NORMAL position.
Where do I go next?
To complete your system, go to “AC Hookups” on page 9. If
you want to connect video components to enjoy surround
sound when watching TV programs or video tapes, go on to
the next section.
TV/VCR Hookups
Overview
This section describes how to connect video
components to the receiver. For specific locations of the
jacks, see the illustration below.
What cables will I need?
• Audio/video cable (not supplied) (1 for each TV or LD
player; 2 for each VCR)
• Video cable (not supplied) (1 for a TV monitor)
Hookups
The arrow ç indicates signal flow.
TV tuner or DBS (Digital Broadcasting Satellites) receiver
Monitor
If you are using your TV as a monitor, do not connect
anything to the TV IN jacks.
INPUTSURROUND OUT
CENTER
WOOFER
REAR
Receiver
Amplifier 2
(for center speaker)
POWER SWAP
SWAP NORMAL
VIDEO 2 VIDEO 1LD MONITOR
5.1 INPUT
TV/DBS
Yellow
Yellow
White (L)
Yellow
Red (R)
White (L)
Yellow
Red (R)
Receiver
L
R
L
R
TV/DBS
OUTPUT
VIDEO
IN
AUDIO
IN
VIDEO
AUDIO
TV/DBS
Receiver
MONITOR
OUT 1
INPUT
VIDEO
OUT 2
OUT
Monitor