Filter
Top Products
109
US
Additional Information
• Sound may not be output from the
receiver while the OSD appears on the
TV screen. Press HOME to display the
home menu, then press HOME again.
• Audio signals (format, sampling
frequency, bit length, etc.) transmitted
from an HDMI jack may be suppressed
by the connected equipment. Check
the setup of the connected equipment if
the image is poor or the sound does not
come out of the equipment connected
via the HDMI cable.
• When the connected equipment is not
compatible with copyright protection
technology (HDCP), the image and/or
the sound from the HDMI TV OUT
jack may be distorted or may not be
output. If this is the case, check the
specification of the connected
equipment.
• Set the image resolution of the
playback equipment to more than
720p/1080i to enjoy High Bitrate
Audio (DTS-HD Master Audio, Dolby
TrueHD).
• The image resolution of the playback
equipment may need to be at certain
settings before you can enjoy DSD and
Multi Channel Linear PCM. Refer to
the operating instructions of the
playback equipment.
• Make sure the TV is compatible with
the System Audio Control function.
• If the TV does not have System Audio
Control function, set the “HDMI
Audio Out” settings in HDMI Settings
menu to
– “TV+AMP” if you want to listen to
the sound from the TV speaker and
receiver.
– “AMP” if you want to listen to the
sound from the receiver.
• When you connect the receiver to a
video equipment (projector, etc.),
sound may not be output from the
receiver. In this case, set the “HDMI
Audio Out” to “AMP” in the HDMI
Settings menu (page 94).
• If you cannot listen to the sound of the
equipment connected to the receiver
while TV input is selected on the
receiver
– Be sure to change the input of the
receiver to HDMI when you want to
watch a program on the equipment
connected via HDMI connection to
the receiver.
– Change the TV channel when you
want to watch a TV broadcast.
– Be sure to select the correct
equipment or input you want when
you watch a program from the
equipment connected to the TV.
Refer to the operating instructions of
the TV on this operation.
• When “Analog Direct” is being used,
the sound is not output. Use other
sound field (page 51).
• When using the Control for HDMI
function, you cannot control the
connected equipment using TV’s
remote control.
– Depending on the connected
equipment and TV, you may need to
set up the equipment and TV. Refer
to the operating instructions
supplied with each equipment and
TV.
– Change the input of the receiver to
the HDMI input connected to the
equipment.
• Check that the selected digital audio
input jack is not reassigned to other
inputs (page 83).
The left and right sounds are
unbalanced or reversed.
• Check that the speakers and equipment
are connected correctly and securely.
• Adjust the sound level parameters
using the Speaker Settings menu.