Filter
Top Products
MULTI CHANNEL AV RECEIVER
STR-DH750/STR-DH550
Performing Auto Calibration
You can perform automatic calibration from where you are sitting.
1. Select [Settings] - [Speaker Settings] from the home menu.
2. Select [Auto Calibration].
3. Follow the instructions on the TV screen, then press to select [Start].
The measurement starts in 5 seconds.
The measurement process will take approximately 30 seconds with a test tone.
When the measurement ends, a beep sounds and the screen switches.
4. Select the item you want.
Retry: Performs the Auto Calibration again.
Save&Exit: Saves the measurement results and exits the setting process.
WRN Check: Displays warning related to the measurement results. See “List of messages after Auto
Calibration measurements.”
Exit: Exits the setting process without saving the measurement results.
For details on the measurement results, see “Checking Auto Calibration results.”
5. Save the measurement results.
Select [Save&Exit] in step 4.
Note
If an error code or warning message appears on the screen in step 3, see “List of messages after Auto
Calibration measurements.”
This setting is not available when headphones are connected.
Hint
The Auto Calibration function will be canceled if you perform the following during the measurement process:
Press .
Press the input buttons on the remote control or turn the INPUT SELECTOR on the receiver.
Press
.
Press SPEAKERS on the receiver.
Change the volume level.
Connect headphones.
Related Topic
About Auto Calibration
Help Guide
114