Filter
Top Products
51
US
Amplifier Operations
Adjusting the equalizer
(EQ menu)
You can use the EQ menu to adjust the tonal
quality (bass/treble level) of the front
speakers.
Select “EQ” in the amplifier menus. For
details on adjusting the parameters, see
“Navigating through menus” (page 42) and
“Overview of the menus” (page 43).
EQ menu parameters
x BASS (Front speakers bass
level)*
x TREBLE (Front speakers treble
level)*
* You can also adjust the front speaker bass and
treble level with TONE MODE and TONE +/– on
the receiver (page 7).
Note
This function does not work in the following cases.
– Dolby TrueHD signals with a sampling frequency
of more than 96 kHz are being received.
– PCM signals with a sampling frequency of more
than 96 kHz are being received.
Settings for the tuner
(TUNER menu)
You can use the TUNER menu to set the FM
station receiving mode, name preset stations
and check XM Radio status.
Select “TUNER” in the amplifier menus. For
details on adjusting the parameters, see
“Navigating through menus” (page 42) and
“Overview of the menus” (page 43).
TUNER menu parameters
x FM MODE (FM station receiving
mode)
•STEREO
This receiver will decode the signal as stereo
signal when the radio station is broadcast in
stereo.
• MONO
This receiver will decode the signal as mono
signal regardless of the broadcast signal.
x NAME IN (Naming preset
stations)
Lets you set the name of preset stations. For
details, see “Naming preset stations” (page
67).
x XM ANT AIM (XM antenna aiming
mode)
This parameter helps you to aim the XM
antenna for optimal signal reception. For
details, see “Aiming the XM antenna (aerial)”
(page 69).
x XM ID (XM Radio ID)
Lets you check the XM Radio ID number. For
details, see “Checking the XM Radio ID”
(page 69).