Filter
Top Products
masterpage:Left
lename[E:\SEM_Janet\Data_DE998\J9041624_2580804111DE998U\2580804111\GB08REM_
S
TR-DE998-U.fm]
54
US
model name1[STR-DE998]
[2-580-804-11(1)]
6 Press the appropriate button on the
remote control to be learned to send
the remote button code.
Lightly pressing the button once should be
sufficient.
If learning is completed successfully, the
indicator slowly flashes twice and the
remote automatically exits the learning
mode.
When learning is not completed
successfully, the indicator flashes 4 times in
quick succession and the procedure returns
to step 6.
If the memory of the remote is already full,
the indicator flashes 8 times in quick
succession and the remote automatically
exits the learning mode.
Notes
• You can program more than 80 keys for the Learning
function. In some cases, you may not be able to
program even if you have not programmed 80
buttons. The number of buttons you can program for
each input button are shown in the following table.
• In steps 2 and 4, the indicator turns off while a valid
button is pressed.
• In step 4, if several buttons that can be used for
learning are pressed, only the last pressed button is
valid. The indicator flashes slowly, it turns ON while
a valid button is pressed.
• In step 6, if a button that can be used for learning is
pressed, the new button is selected and the learning
procedure returns to the beginning of step 6.
To activate the input source after
programming
Press the programmed button to activate the
input you want.
To cancel learning
Press RM SET UP during any step. The remote
automatically exits the learning mode.
To clear the learned codes
Start over from step 1. After step 4, press
TV ?/1 for more than 2 seconds. The indicator
lights up twice slowly and the learned code is
cleared. If TV ?/1 is pressed less than 2
seconds, the learning procedure returns to the
beginning of step 6.
When a learned code is cleared, if the button was
previously programmed for another input
selector, the programmed code for that button
can be used.
To clear the memory of the
remote
To clear all programmed and learned signals, do
the following to reset the remote to factory
settings.
Press ?/1, AV ?/1 and MASTER VOL – at
the same time.
The indicator flashes 3 times, then goes off.
To use a command that has been
learned
When selecting a learned input, press the learned
button for that input.
Input Number of Buttons
you can program
VIDEO 1, VIDEO 2,
DVD
78 keys
VIDEO 3, TV/SAT,
TAPE
78 keys
MD/DAT, SA-CD/CD,
TUNER
78 keys
PHONO, MULTI CH 52 keys
TV buttons, (TV ?/1,
TV VOL +/– , TV CH +/–,
WIDE, TV/VIDEO
7 keys
GB01COV_STR-DE998-U.book Page 54 Monday, January 17, 2005 2:49 PM