Filter
Top Products
Additional Information
masterpage:Right
lename[E:\SEM_Janet\Data_DB895D\J9050665_2598514111DB895DCEL\2598514111\GB09
A
DD_STR-DB895D-CEL.fm]
63
GB
model name1[STR-DB895D]
[2-598-514-11(1)]
There is no picture or an unclear picture
appears on the TV screen or monitor.
• Select the appropriate input on the receiver.
• Set your TV to the appropriate input mode.
• Move your audio components away from the TV.
The DIGITAL OPTICAL MD/TAPE OUT jack
flashes red.
• When “AUTO IN” is selected for INPUT MODE,
the jack flashes red when no digital audio signal is
input. This is depends on the INPUT MODE
function, and is not a malfunction.
Remote control
The remote does not function.
• The 12, AUX and SOURCE buttons on the remote
are not available for receiver operation.
• Point the remote at the remote sensor on the
receiver.
• Remove any obstacles in the path between the
remote and the receiver.
• Replace all the batteries in the remote with new
ones, if they are weak.
• Check if the command modes of the receiver and
the remote is the same. If the command mode of
the receiver and the remote is different, you
cannot operate the receiver with the remote. To
change the command mode of the receiver, see
“Changing the command mode of the receiver”
(page 48) and to select the command mode of the
remote, see “Selecting the command mode of the
remote” (page 56).
• Make sure you select the correct input on the
remote.
• You need to assign a component to the AUX and
MULTI CH buttons before you can use the
buttons to control your audio/video equipment.
For details, refer “Programming the remote” on
page 56.
• To activate the buttons with orange printing, press
ALT first before pressing the buttons.
• Before you use the V/v/B/b button for receiver
operation, press MAIN MENU. To operate other
components, press TOP MENU/GUIDE or AV
MENU after pressing the function button.
Error messages
If there is a malfunction, the display shows a
message. You can check the condition of the
receiver by the message. Refer to the following
table to solve the problem.
DEC. ERR.
Appears when the signal which the receiver cannot
decode (ex. DTS-CD) is input when “DEC. XXXX”
in the CUSTOMIZE menu is set to “DEC. PCM”.
Set to “DEC. AUTO”.
PROTECT
Irregular current is output from the speakers. The
receiver will automatically turn off after a few
seconds. Check the speaker connection and turn on
the power again. If this problem persists, consult
your nearest Sony dealer.
DAB EROR
The receiver is unable to collect the DAB data. Turn
off the receiver and turn it on again.
If you are unable to remedy the
problem using the
troubleshooting guide
Clearing the receiver’s memory may remedy the
problem (page 18). However, note that all
memorized settings will be reset to their factory
settings and you will have to readjust all settings
on the receiver.
If the problem persist
Consult your nearest Sony dealer.
Reference sections for clearing
the receiver’s memory
To clear See
All memorized settings page 18
Customized sound fields page 43
GB01COV_STR-DB895D-CEL.book Page 63 Wednesday, June 15, 2005 9:28 AM