Filter
Top Products
7
EN
Rear and center speakers
Active woofer
If you have an additional front speaker system
Connect them to the FRONT SPEAKERS B terminals.
If your TV monitor uses separate speakers
You can connect one of them to the SURROUND
SPEAKER CENTER terminals for use with Dolby Pro
Logic Surround Sound (see page 18).
Selecting the impedance (STR-DE705 and
STR-D650Z only)
Set the IMPEDANCE SELECTOR for the front speakers
as indicated in the table below. Check the instruction
manual of your speakers if you’re not sure of the
impedance. (This information is usually printed on a
label on the back of the speaker.)
Selecting the speaker system
If you connect only one set of front speakers, set the
SPEAKERS selector on the front panel to A. If you
connect two sets of front speakers, see the following:
} ]
} ]} ]
Rear speaker
(R)
Rear speaker
(L)Center speaker
Yellow
Yellow
White (L)
Yellow
Red (R)
White (L)
Yellow
Red (R)
(continued)
Where do I go next?
To complete your system, go to “AC Hookups” on page 8. If
you want to connect video components to enjoy surround
sound when watching TV programs or video tapes, go on to
the next section.
TV/VCR Hookups
Overview
This section describes how to connect video
components to the receiver. For specific locations of the
jacks, see the illustration below.
What cables will I need?
• Audio/video cable (not supplied) (1 for each TV or LD
player; 2 for each VCR)
• Video cable (not supplied) (1 for a TV monitor)
Hookups
The arrow ç indicates signal flow.
TV or Digital Broadcasting System (DBS) tuner
if nominal impedance of
your speaker is
Between 4 and 8 ohms
8 ohms or higher
Set IMPEDANCE SELECTOR to
4 Ω
8 Ω
To drive
Speaker system A (connected
to the FRONT SPEAKERS A
terminals)
Speaker system B (connected
to the FRONT SPEAKERS B
terminals)
Both speaker systems A and
B (parallel connection)
Set SPEAKERS selector to
A
B
A+B*
*Do not use A+B with SOUND FIELD set to ON.
SURROUND SPEAKERS
IMPEDANCE USE 8-16 Ω
REARLR CENTER
LR
Receiver
MIX
AUDIO
OUT
INPUT
Receiver Active woofer
TVMONITOR VIDEO 2
VIDEO 1
Getting Started
L
R
L
R
TV/DBS
OUTPUT
VIDEO
IN
AUDIO
IN
CTRL S
STATUS IN
VIDEO
AUDIO
Receiver TV
or
DBS tuner