Sony ST-SA3ES Stereo System User Manual


 
6
GB
ANTENNA
AFMB
AM
y
75 COAXIAL
RL
LINE OUT
ANTENNA
AFMB
AM
y
75 COAXIAL
RL
LINE OUT
Connecting a ground wire
If you connect an outdoor aerial, be sure to connect a
ground wire (not supplied) to the AM ANTENNA y
terminal (in addition to the AM loop aerial) for
lightning protection.
Amplifier hookups
Connect the tuner to an amplifier. Be sure to turn off
the power to both components before connection. For
the specific location of the terminals, see the illustration
below.
What cables will I need?
Audio cord (supplied) (1)
Connect the white plugs to the white (L) jacks and the red
plugs to the red (R) jacks. Insert the plugs completely into
the jacks; incomplete connections may cause noise.
Mains lead hookup
Connect the mains lead to a wall outlet after completing all
of the previous connections.
Getting Started
Red (R)
White (L)
Red (R)
White (L)
LINE OUT
/
to a wall outlet
TUNER IN
RL
RL
LINE OUT
Amplifier
FM aerial hookups
With an FM outdoor aerial, you can obtain a higher FM
broadcast sound quality. We recommend that you use
the supplied FM wire aerial only temporarily until you
install an FM outdoor aerial. For the specific location of
the FM ANTENNA terminal, see the illustration below.
What will I need?
FM wire aerial (supplied) (1)
FM outdoor aerial (not supplied) (1) and 75-ohm coaxial
cable (not supplied) (1)
Connect the supplied FM wire aerial or an FM outdoor
aerial (not supplied) to one of the FM terminals on the
back of this unit.
z You can use two FM aerials
This tuner has two FM ANTENNA terminals, A and B,
for use with different types of FM aerials. For example,
you can connect an outdoor aerial to the A jack and
connect a cable aerial to the B jack. You can also switch
the aerial while using the signal meter to determine
which aerial gives the best reception for a particular
station.
ANTENNA
AFMB
AM
y
75 COAXIAL
RL
LINE OUT
FM ANTENNA
IEC female type connector
FM wire aerial
ANTENNA
AFMB
75 COAXIAL
ANTENNA
AFMB
75 COAXIAL
FM outdoor aerial
IEC female type
connector