Filter
Top Products
5
GB
ANTENNA
AFMB
AM
y
75 COAXIAL
RL
LINE OUT
Unpacking
Check that you received the following items with the
tuner:
• Audio cord (1)
• AM loop aerial (1)
• FM wire aerial (1)
Getting Started
Hooking up the System
Before you get started
• Turn off the power to all components before making any
connections.
• Do not connect the mains lead until all of the connections
are completed.
• Be sure to make connections firmly to avoid hum and
noise.
• When connecting an audio cord, be sure to match the
colour-coded pins to the appropriate jacks: White (left) to
White; and Red (right) to Red.
AM aerial hookups
This section describes how to connect the supplied AM loop
aerial and an insulated wire (not supplied). For the specific
location of the AM ANTENNA terminals, see the illustration
below.
What will I need?
• AM loop aerial (supplied) (1)
1 Before assembling the supplied aerial, pull the
lead wire out from the slot in the aerial frame.
2 Unwrap 3 lengths of the braided lead wire from
around the frame of the aerial. Be careful to
unwrap only the braided section of the lead wire.
Do not unwrap more than 3 lengths of the lead
wire. Also, be careful not to unbraid the lead wire.
AM ANTENNA
3 Assemble the supplied aerial as shown below.
4 Connect the AM loop aerial to the AM terminals
on the back of this unit. For best reception,
connect an insulated wire (not supplied) in
addition to the AM loop aerial. (See “For best AM
reception” below.)
5 Adjust the aerial direction for the best reception.
The AM loop aerial has a directivity which detects
the signal from some angles more strongly than
others. Set the aerial to the orientation which
provides the best receiving condition.
z For stations that are difficult to receive
Try repositioning the loop aerial while tuning. Placing the
supplied AM loop aerial near a window will help improve
reception quality.
z For best AM reception
Connect a 6 to 15-meter insulated wire (not supplied) to the
AM aerial terminal in addition to the AM loop aerial. Try to
extend the wire outdoors and keep it horizontal.
Do not disconnect the AM loop aerial.
Connecting a ground wire
If you connect an outdoor aerial, be sure to connect a
ground wire (not supplied) to the AM ANTENNA y
terminal (in addition to the AM loop aerial) for
lightning protection.
ANTENNA
AM
y
Insulated wire
AM loop aerial
(continued)