Filter
Top Products
56
US
STR-DE985/DE885 4-238-488-12(1) US
5 Press the appropriate button on the
remote control to be learned to send
the remote button code.
Lightly pressing the button once should be
sufficient.
If learning is completed successfully, the
indicator slowly flashes twice and the
remote automatically exits the learning
mode.
When learning is not completed
successfully, the indicator flashes 4 times in
quick succession and the procedure returns
to step 5.
If the memory of the remote is already full,
the indicator flashes 8 times in quick
succession and the remote automatically
exits the learning mode.
Notes
• You can program more than 80 keys for the
Learning function. In some cases, you may not be
able to program even if you have not programmed
80 buttons. The number of buttons you can program
for each FUNCTION button are shown in the
following table.
FUNCTION button area Number of Buttons
you can program
VIDEO 1, VIDEO 2, 78 keys
DVD/LD
VIDEO 3, TV/SAT, 78 keys
TAPE
MD/DAT, CD/SACD, 78 keys
TUNER
PHONO, MULTI CH 52 keys
TV buttons (TV ?/1, 7 keys
TV VOL +/–, TV CH +/–,
WIDE, TV/VIDEO)
• In steps 2 and 3, the indicator turns off while a valid
button is pressed.
• In step 3, if several buttons that can be used for
learning are pressed, only the last pressed button is
valid. The indiactor blinks slowly, it turns ON while
a valid button is pressed.
• In step 5, if a button that can be used for learning is
pressed, the new button is selected and the learning
procedure returns to the beginning of step 5.
To activate the function after
programming.
Press the programmed button to activate the function
you want.
To cancel learning
Press USE MODE during any step. The remote
automatically exits the learning mode.
To clear the learned codes
Start over from step 1. After step 3, press
TV ?/1 for more than 2 seconds. The indicator
lights twice slowly and the learned code is
cleared. If TV ?/1 is pressed less than 2
seconds, the learning procedure returns to the
beginning of step 5.
When a learned code is cleared, if the button
was previously programmed for another
function, the programmed code for that button
can be used.
To clear the memory of the remote
To clear all programmed and learned signals,
do the following to reset the remote to factory
settings.
At the same time, press ?/1, AV ?/1, and
MASTER VOLUME.
The indicator flashes 3 times, then goes off.
To use a command that has been
learned
When selecting a learned function, press the
learned button for that function.
Learning the commands of your
components (continued)
01GB09OPEUS.p65 25/3/02, 02:48 PM56