Filter
Top Products
Additional Information
50
GB
General
System Tuner section:
PLL quartz-locked
digital synthesizer
system
Preamplifier section:
Low-noise NF type
equalizer
Power amplifier section:
Pure-complementary
SEPP
Power requirements
Models of area code AU:
240 V AC, 50 Hz
Models of area code SP,
CN:
220 - 230 V AC,
50/60 Hz
Models of area code E2,
E3:
120/220/240 V AC,
50/60 Hz
Models of area code TW:
110V AC, 50/60 Hz
Power consumption
Models code area code
AU, E2, E3:
210 W
In standby condition:
1 W
Models code area code
SP, CN:
210 W
In standby condition:
1 W
Models code area code
TW:
410 W
In standby condition:
1 W
AC outlets 1 switched, total 100 W
maximum (except
models of area code
CN)
Dimensions 430 × 308.5 × 157.5 mm
including projecting
parts and controls
Mass (Approx.)
7.5 kg
Supplied accessories
See page 4.
For details on the area code of the
component you are using, see
page 3.
The specification measured is under
• 230 V AC 50 Hz condition (models of
area code SP, CN).
• 240 V AC 50 Hz condition (models of
area code AU, E2, E3).
• 110 V AC 50 Hz condition (models of
area code TW).
Design and specifications are subject to
change without notice.
Specifications
AM tuner section
Tuning range Models of area code AU,
SP, CN
531 - 1602 kHz (9 kHz
step)
Models of area code E2,
E3, TW
530 - 1610 kHz (10 kHz
step)
c)
531 - 1602 kHz (9 kHz
step)
c)
Antenna Loop antenna
Intermediate frequency
450 kHz
Usable sensitivity
50 dB/m (at 999 kHz)
S/N 54 dB (at 50 mV/m)
Harmonic distortion
0.5 % (50 mV/m,
400 Hz)
Selectivity At 9 kHz: 35 dB
At 10 kHz: 40 dB
c) You can change the AM tuning interval to
10 kHz. After tuning in any AM station,
turn off the receiver. Hold down the
TUNING + button and press the 1/u
button. All preset stations will be erased
when you change the tuning interval. To
reset the scale to 10 kHz, repeat the
procedure.
Video section
Inputs Video: 1 Vp-p 75 ohms
S-video:
Y: 1 Vp-p 75 ohms
C: 0.286 Vp-p 75 ohms
Outputs Video: 1 Vp-p 75 ohms
S-video:
Y: 1 Vp-p 75 ohms
C: 0.286 Vp-p 75 ohms