Filter
Top Products
Additional Information
masterpage:Right
lename[C:\Data\Sony SEM_Janet\STR-
DE597_Data\J904000_4252271121DE597UCA\4252271121\4252271121DE597UCA\GB09AD
D_STR-DE597-UCA.fm]
49
GB
model name1[STR-DE597]
[4-252-271-12(1)]
Error messages
If there is a malfunction, the display shows a
message. You can check the condition of the
receiver by the message. Refer to the following
table to solve the problem.
DEC. EROR
Appears when the signal which the receiver cannot
decode (ex. DTS-CD) is input when “DEC. XXXX”
is set to “DEC. PCM”. Set to “DEC. AUTO”.
PROTECT
Irregular current is output from the speakers. The
receiver will automatically turn off after a few
seconds. Check the speaker connection and turn on
the power again. If this problem persists, consult
your nearest Sony dealer.
If you are unable to remedy the
problem using the
troubleshooting guide
Clearing the receiver’s memory may remedy the
problem (page 17). However, note that all
memorized settings will be reset to their factory
settings and you will have to readjust all settings
on the receiver.
If the problem persist
Consult your nearest Sony dealer.
Reference sections for clearing
the receiver’s memory
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
(Models of area code U only)
With 8 ohm loads, both channels driven, from
20 – 20,000 Hz; rated 90 watts per channel
minimum RMS power, with no more than
0.09% total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
Power Output
Models of area code U, CA
Rated Power Output at Stereo Mode
(8 ohms 20 Hz – 20 kHz, THD 0.09%)
90 W + 90 W
1)
Reference Power Output
1)
(8 ohms 20 Hz – 20 kHz, THD 0.09%)
FRONT
2)
: 90 W/ch
CENTER
2)
: 90 W
SURR
2)
: 90 W/ch
SURR BACK
2)
: 90 W
(8 ohms 1 kHz, THD 0.7%)
FRONT
2)
: 100 W/ch
CENTER
2)
: 100 W
SURR
2)
: 100 W/ch
SURR BACK
2)
: 100 W
Models of area code CEL, CEK
Rated Power Output at Stereo Mode
(8 ohms 1 kHz, THD 0.7%)
100 W + 100 W
1)
Reference Power Output
1)
(8 ohms 1 kHz, THD 0.7%)
FRONT
2)
: 100 W/ch
CENTER
2)
: 100 W
SURR
2)
: 100 W/ch
SURR BACK
2)
: 100 W
Models of area code E2/E3, TW
Rated Power Output at Stereo Mode
(8 ohms 1 kHz, THD 0.7%)
100 W + 100 W
1)
Reference Power Output
1)
(8 ohms 1 kHz, THD 10%)
FRONT
2)
: 120 W/ch
CENTER
2)
: 120 W
SURR
2)
: 120 W/ch
SURR BACK
2)
: 120 W
To clear See
All memorized settings page 17
Customized sound fields page 36
Specifications
continued
GB01COV_STR-DE597-UCA.book Page 49 Monday, March 8, 2004 12:15 PM